top of page

防滑添加剂

MasterMax 防滑添加剂
mastermax防滑
  • 纹理粉末,赋予装饰性纹理效果

  • 添加到油漆和密封剂中以减少滑动

  • 在人行道、台阶、甲板和车道等区域使用

  • 透明粉末颗粒

  • 每 4 升涂料添加 200 克

  • 200 克

按照建议用量 50 g/L(5 大汤匙)将MASTERMAX 防滑添加剂添加到涂料中,根据 AS/NZS 4586:2004 测试,在潮湿条件下 BPN 值为 42,在干燥条件下 COF 值为 0.85。f

MASTERMAX防滑添加剂可轻松均匀地分散到涂层中,为涂层提供非磨蚀性防滑效果。防滑添加剂是一种无害的纹理剂(不含结晶二氧化硅)。测试样品以确定您的应用是否合适。

PDF 表格
PDF 表格
Non Slip Additive - by MASTERMAX

Non Slip Additive - by MASTERMAX

播放影片
如何指导和建议
此語言尚未有已發佈之文章
文章發佈後將於此處顯示。
MasterMax 防滑添加剂

PRODUCT INFORMATION

DESCRIPTION:

NON-SLIP ADDITIVE is a unique coarse, texturising powder added to coatings to reduce slip on surfaces such as paths, floors, decks and driveways. 

PRINCIPAL USES:

As a Non-Slip Additive for coatings applied to walking surfaces to meet the requirements of the New Zealand Building Code D1.3.3(d).  

 

Can also be used to give a decorative textured or effect finish to coatings and for aesthetic effect.

 

FEATURES:

NON-SLIP ADDITIVE disperses easily and evenly through the coating giving a non-abrasive slip resistant finish to the coating.  

 

NON-SLIP ADDITIVE is a non-hazardous texturising agent that is free of crystalline silica and is lighter in weight and less abrasive than mineral texturising agents.  

 

Tested to AS/NZS 4586:2004 NON-SLIP ADDITIVE added to a water based paving paint at the recommended level gives, in wet conditions, 42 BPN and, in dry conditions, a COF of 0.85. This gives the water based paving paint containing NON-SLIP ADDITIVE a rating of F - Moderate to Very Low slip resistance when dry under AS/NZS4586:2004 and X - Moderate Slip resistance when wet according to HB 197:1999.

 

LIMITATIONS:

For use as a decorative textured or effect finish produce a test sample to determine if it is suitable for your application and gives the expected effect.

 

APPEARANCE: Clear Powdered Granules. NON-SLIP ADDITIVE normally does not change the product colour but does need to be checked prior to application.

 

APPLICATION DATA:

Refer to the Technical Data Sheet of the product to which NON-SLIP ADDITIVE is being added.  

 

Add slowly to the coating whilst stirring and mix thoroughly. Leave to stand for a minimum of 5 minutes, then mix again immediately prior to use and each time you use the product. Apply the paint evenly and generously. To ensure an even texture do not overwork or overbrush the finish.  

 

After application of the recommended primer coats (with the additive), at least two full finish coats of the paint containing  NON-SLIP ADDITIVE are required.

 

GENERAL DATA

Addition Level:

50 g/L to achieve the requirements of New Zealand Building Code D1.3.3(d). This is approximately 5 heaped tablespoons and for 4 litres this is 200 g.  

 

For decorative effects add any amount required to achieve the desired texture to a maximum loading of 200 g/L.

 

Gloss Level:

Due to the texturing nature of NON-SLIP ADDITIVE it will slightly reduce the gloss level of the product to which it is added.  

 

Application Temperature:

Refer to the Technical Data Sheet of the product to which MM NON-SLIP ADDITIVE is being added.

 

Shelf Life: Store in cool conditions, away from direct sunlight. Under normal conditions MM NON-SLIP ADDITIVE can be stored for several years.

 

Specific Gravity:

0.90

Sizes Available:          

200 g Packs  

 

HEALTH & SAFETY

Non-hazardous plastic granules containing no crystalline silica. Take normal precautions for handling plastic granules i.e. do not ingest, avoid inhaling dust when pouring into paint.

 

Refer MSDS, available on request, for detailed safety instructions.  See Above: 

Non slip reviews

★★★★★ 5 星,满分 5 星。

· 一年前

门廊上不再滑倒。

很棒的产品。易于与 pavemax 混合。门廊不再湿滑。

派罗瓦

独家
mitre10 徽标

大师

邮政信箱 16017,霍恩比,基督城 8441,新西兰。

  • Instagram
  • Facebook
  • YouTube

0800 300 585 | +64 3 344 0260

MasterMax 徽标

MASTERMAX 由 Agrippa Paints Ltd 自豪制造

ToiTu 和新西兰制造的标志

© 版权所有 2024 MASTERMAX NZ Ltd. 保留所有权利。

bottom of page